Operating Tips
NOTE: Allow the engine to warm up for a few minutes as the engine will not develop full power until it reaches operating temperature.
WARNING: Muffler, engine and surrounding areas become hot and can cause a burn. Do not touch.
•Set the skid shoes 1/4" below the shave plate for
normal usage. The skid shoes may be adjusted upward (to lower the shave plate) for
•Remove snow immediately after it falls.
•Discharge snow downwind whenever possible.
•Slightly overlap each previous cleared path.
•Follow the precautions found under the heading To Stop Engine to prevent possible
•Clean the snow thrower thoroughly after each use.
SECTION 6: MAKING ADJUSTMENTS
WARNING: Never attempt to make any adjustments while the engine is running, except where specified in operator’s manual.
Chute Assembly Adjustment
The distance snow is thrown can be adjusted by adjusting the angle of the chute assembly. Refer to Chute Tilt Control in Section 4 of this manual.
Chute Directional Control
Support Bracket Adjustment
If the spiral at the base of the chute directional control isn’t fully engaging with the notches in the lower chute assembly, the support bracket can be adjusted inward or outward as follows:
•Loosen, but do NOT remove the two hex nuts which secure the chute directional control support bracket to the snow thrower housing. See Figure 9.
| Spiral |
Hex Nuts | Support Bracket |
|
Figure 9
•Adjust the support bracket inward or outward so that the spiral is fully engaged in the notches on the chute before retightening the hex nuts.
Skid Shoe Adjustment
The space between the shave plate and the ground can be adjusted by raising or lowering the skid shoes. Refer to Skid Shoe Adjustment in Section 3 of this manual.
Auger Control Adjustment
Refer to the information found under the heading Final Adjustments in Section 3 of this manual to adjust the auger control.
Traction Control Adjustment
Refer to the information found under the heading Final Adjustments in Section 3 of this manual to adjust the traction control. If you are uncertain that you have reached the correct adjustment, proceed as follows:
•Tip the snow thrower forward, allowing it to rest on the auger housing.
•Remove the frame cover underneath the snow thrower by removing six
With the traction control released, there must be clearance between the friction wheel and the drive plate in all positions of the shift lever.
With the traction control engaged, the friction wheel must contact the drive plate. See Figure 10.
Friction
Wheel
Gear Shaft
Drive
Plate
Figure 10
If adjustment is necessary:
•Loosen the jam nut on the traction drive cable and thread the cable in or out as necessary.
10
