USING THE HYDRAULIC LIFT LEVER
The hydraulic lift system provides power for raising and positioning three point hitch and belly mounted equipment. To raise an attachment using the hydraulic lift system, the engine must be running. Generally, an attachment can be lowered with the engine running or off.
•Move the lift lever forward in the slot to lower the equipment to the desired height setting. Refer to Figure 20.
•Move the lift lever rearward in the slot to raise the equipment.
•Move the lift lever fully forward and to the right ahead of the float lock gate to lock the lift in the float position.
Raise
Lower 
Float
HYDRAULIC
LIFT LEVER
FLOAT LOCK
GATE
Figure 20
ENGAGING THE PTO
WARNING: The operator must be in the seat at all times when the PTO is engaged. If the operator should leave the seat without turning off the PTO switch, the tractor’s engine will shut off.
•Move the throttle handle to the mid throttle position. See Figure 21.
•Push the top of the PTO switch downward to engage the PTO (See Figure 21). The PTO light on the instrument panel will come on.
•Observing the tachometer on the instrument panel, use the throttle handle to increase the engine speed to the PTO operating range
•Push the bottom of the switch downward to disengage the PTO.
IMPORTANT: Normally the PTO will not operate when the tractor is driven in the reverse direction. The PTO reverse override switch must be activated to operate the PTO while traveling in reverse.
THROTTLE HANDLE 
Mid Throttle
to Engage
3500 RPM
to Run
PTO SWITCH
Figure 21
USING THE PTO REVERSE OVERRIDE SWITCH
The PTO reverse override switch, located on the left fender, allows the PTO to operate while the tractor is traveling in the reverse direction. Refer to Figure 17.
•The PTO should first be engaged using the PTO switch on the dash panel.
•Depress the front of the override switch to activate the reverse override system. The light in the override switch will come on.
IMPORTANT: Once activated, the reverse override will remain activated until the ignition switch is turned to the OFF position. If the over- ride switch is illuminated, the system is activated.
WARNING: Use EXTREME CAUTION when operating PTO driven attach- ments while traveling in the reverse direction.
LIGHTING
Headlights
Always use the headlights for after dusk and pre- dawn operation of the tractor. The lights not only illuminate the work area, but also increase the visibility of the tractor for anyone who might enter the area of operation.
•To turn on the headlights, depress the top end of the headlight switch located to the left of the steering wheel.
•To turn off the headlights, depress the bottom of the light switch.
Use of the headlights, along with a SMV (Slow Moving Vehicle) emblem, is also recommended when operating the tractor on or near roadways to increase visibility to traffic.
19
