•Turn the bulb/socket assembly approximately a quarter turn counterclockwise to align its tabs with the notches of the reflector, then remove from the reflector. See Figure 36.
REFLECTOR
WIRE
HARNESS
PLUG
BULB/SOCKET
ASSEMBLY
Figure 36
•Replace with a new bulb/socket assembly (Cub Cadet No.
•Align the tabs of the new bulb/socket assembly with the notches of the reflector and insert the bulb.
•Turn the bulb/socket assembly clockwise to lock in place. Push the wire harness plug fully into the bulb socket.
HAZARD BULB REPLACEMENT
Flashing hazard lights are installed on each side of the ROPS. Referring to Figure 37, replace the bulbs as follows:
SOCKET
Push in |
and Turn |
BODY
BULB
AMBER 
LENSE
Figure 37
•Insert a thin bladed screwdriver, or similar tool, between an amber lense and the hazard light body, then twist to separate the lense from the body. Refer to Figure 37.
•Push the bulb inward and turn counterclockwise, then pull the bulb outward to remove from the light socket. Refer to Figure 37.
•Align the new bulb with the socket slot, push the bulb into the socket, and turn clockwise to lock it in the socket.
•Position the lense on the hazard light body and push the lense onto the body until it snaps firmly into place on the body.
SERVICING ELECTRICAL SYSTEM
Fuses are installed to protect the tractor’s electrical system from damage caused by excessive amper- age. Always use the same capacity fuse for replacement. If the electrical system does not func- tion, check for blown fuses. See Figure 38
If you have a recurring problem with blown fuses, have the tractor’s electrical system checked by your Cub Cadet dealer.
GOOD BAD
Figure 38
Main Fuse
The main fuse in the tractor wire harness protects the tractor’s entire electrical system. A blown main fuse will prevent battery current from passing though the harness.
To replace the main fuse:
•Raise the tractor hood.
•Locate the main fuse on the lower/right pedes- tal beneath the dash panel. See Figure 39.
FUSE HOLDER
MAIN FUSE
WIRE
DASH 
HARNESS PANEL
Figure 39
•Pull the fuse from the fuse holder and replace with the same capacity fuse (30 Amp). NEVER use a higher amperage fuse.
•Lower the tractor hood.
30
