•Turn the bulb/socket assembly approximately a quarter turn counterclockwise to align its tabs with the notches of the reflector, then remove from the reflector.
REFLECTOR
WIRE
HARNESS
PLUG
BULB/SOCKET
ASSEMBLY
Figure 35
•Replace with a new bulb/socket assembly (Cub Cadet No.
•Align the tabs of the new bulb/socket assembly with the notches of the reflector and insert bulb.
•Turn the bulb/socket assembly clockwise to lock in place. Push the wire harness plug fully into the bulb socket.
AZARD BULB REPLACEMENT
Hazard lights are installed on each side of the ROPS. To replace the bulbs proceed as follows:
•Insert a thin bladed screwdriver, or similar tool, between an amber lense and the hazard light body, then twist to separate the lense from the body. See Figure 36.
SOCKET
Push in
and Turn
AMBER 
LENSE
BULB
BODY
Figure 36
•Push the bulb inward and turn counterclockwise, then pull the bulb outward to remove from the light socket. Refer to Figure 36.
•Align the new bulb with the socket slot, push the bulb into the socket, and turn clockwise to lock it in the socket.
•Position the lense on the hazard light body and push the lense onto the body until it snaps firmly into place on the body.
SERVICING ELECTRICAL SYSTEM
Fuses are installed to protect the tractor’s electrical system from damage caused by excessive amper- age. Always use the same capacity fuse for replacement. If the electrical system does not func- tion, check for blown fuses. See Figure 37
If you have a recurring problem with blown fuses, have the tractor’s electrical system checked by your Cub Cadet dealer.
GOOD BAD
Figure 37
Main Fuse
The main fuse in the tractor wire harness protects the tractor’s entire electrical system. A blown main fuse will prevent battery current from passing though the harness.
To replace the main fuse:
•Raise tractor hood and remove right side panel.
•Locate the fuse holder on the front of the bulk- head, just inside the right side of the dash panel. Refer to Figure 38.
•Pull the main fuse from the fuse holder and replace with the same capacity fuse (30 Amp).
NEVER use a higher amperage fuse.
•Install side panel and lower tractor hood.
FUSE HOLDER
|
|
|
| MAIN |
DASH |
| FUSE | ||
PANEL |
|
| ||
BULKHEAD |
|
| ||
GLOW |
|
| ||
PLUG |
|
|
|
|
|
|
| ||
RELAY |
|
| ||
Figure 38
30
