Cub Cadet 5264D manual A. Steering Wheel, B. Throttle Handle, C. PTO Switch, D. Ignition Switch

Models: 5264D

1 48
Download 48 pages 35.89 Kb
Page 10
Image 10
A. Steering Wheel

NOTE: References to LEFT and RIGHT indicate that side of the tractor when facing forward while seated in the drivers seat. Reference to FRONT indicates the grille end of the tractor; to REAR, the tow plate end.

A. Steering Wheel

The steering wheel is centered on the dash panel, and used to change the direction (left or right) of the tractor while driving.

NOTE: This tractor is equipped with hydraulic power steering. With this feature, the cap and spokes of the steering wheel may change position.

B. Throttle Handle

This symbol indicates the fast position.

This symbol indicates the slow position.

The throttle handle is located to the right of the steering wheel on the dash panel. When set in a given position, a uniform engine speed will be maintained. Rotate the handle rearward to increase the engine speed.

C. PTO Switch

PTO

Switch

Symbol

Figure 2

The PTO switch is a rocker type switch located to the right of the steering wheel on the dash panel. Push the top of the PTO switch downward to engage the PTO. Push the bottom of the switch downward to disengage.

D. Ignition Switch

NOTE: To prevent accidental starting and/or battery discharge, remove the key from the ignition switch when the tractor is not in use.

The ignition switch has three positions as follow:

B. Throttle HandleC. PTO SwitchOFF

STOP

D. Ignition SwitchE. Brake PedalF.Reverse PedalON

G. Forward PedalManual backgroundManual backgroundSTART

Figure 3

OFF - Engine and electrical system is turned off.

ON - The tractor electrical system is energized.

START- The starter motor will turn over the engine. Release the key immediately when the engine starts

E. Brake Pedal

Brake Pedal

Symbol

Figure 4

The brake pedal is located at the front of the right running board above the forward and reverse pedals. Depress to engage the tractor brakes and neutralize the hydrostatic transmission. Fully depress the brake pedal to activate the safety interlock switch when starting the tractor.

F.Reverse Pedal

Reverse

Pedal

Symbol

Figure 5

The reverse control pedal is located on the right running board below the brake pedal. Press the pedal down to move in reverse.

WARNING: Check behind the tractor to be sure the area is clear of people, pets or obstacles and use a slower speed to maintain control of the tractor when traveling in reverse.

G. Forward Pedal

Forward

Pedal

Symbol

Figure 6

The forward control pedal is located on the right running board below the brake pedal. Slowly press down on the pedal to start moving forward. The forward ground speed of the tractor is directly affected by the distance the pedal is depressed.

10

Page 10
Image 10
Cub Cadet 5264D A. Steering Wheel, B. Throttle Handle, C. PTO Switch, D. Ignition Switch, E. Brake Pedal, F. Reverse Pedal