Harman-Kardon Comprehensive Guide to Programming Your Receiver Remote - AVR 110

Programming the Remote

2.Press the Play button w. The Program Indicator cwill stop flashing and stay amber.

3.Press and release the Input Selector button efor the device that will be used to change the channels. The Program Indicator cwill blink green three times and then go out to con- firm the data entry.

Example: To control the transport of a DVD player while the remote is set to control the TV, first press the VID 2/TV Input Selector but- ton e and the Mute button 35 at the same time. Next, release them and press the Play button w, followed by the DVD Input Selector button e.

NOTE: To remove the Channel Control Punch- Through and return the remote to its original con- figuration, repeat the steps shown in the example above. However, press the VID 2/TV Input Selector in Steps 1 and 3.

NOTE: Before programming the remote for Volume, Channel or Transport Punch-Through, make certain that any programming needed for the specific TV, CD, DVD, Cable or Satellite Receivers has been completed.

Reassigning Device Control Selectors

Although each Input Selector eis normally assigned to the category of product shown on the remote, it is possible to reassign one of these but- tons to operate a second device of another type. For example, if you have two VCRs but no satellite receiver, you may program the “SAT” button to operate a second VCR. Before following the nor- mal programming steps for either Three-Digit entry or Auto Search code entry, you must first reassign the button with the following steps:

1.Press the Input Selector eyou wish to reassign and the Mute button 35 at the same time until the red light appears under the Input Selector e and the Program Indicator c flashes amber.

2.Press the Input Selector e for the device you wish to program into the reassigned button.

3.Enter the three-digit code for the specific model you wish the reassigned button to operate.

4.Press the same Input Selector epressed in Step 1 once again to store the selection. The red LED under the reassigned Input Selector will flash three times and then go out.

Example: To use the CBL/SAT button to oper- ate a second VCR, first press the CBL/SAT Input Selector eand the Mute button

35 at the same time until the red light glows under the CBL/SAT ebutton. Press the VCR ebutton, followed by the three-digit code for the specific model you wish to control. Finally, press the CBL/SAT ebutton again.

Resetting the Remote Memory

As you add components to your home-theater sys- tem, occasionally you may wish to totally repro- gram the remote control without the confusion of any commands, macros or ”Punch-Through“ pro- gramming that you may have done. To do this, it is possible to reset the remote to the original factory defaults and command codes by following these steps. Note, however, that once the remote is reset, all commands or codes that you have entered will be erased and will need to be re- entered:

1.Press any of the Input Selector buttons e and the ”O“ button rat the same time until the Program Indicator cbegins to flash amber.

2.Press the ”3“ button rthree times.

3.The red LED under the Input Selector ewill go out and the Program Indicator cwill stop flashing and turn green.

4.The Program Indicator cwill remain green until the remote is reset. Note that this may take a while, depending on how many com- mands are in the memory and need to be erased.

5.When the Program Indicator cgoes out, the remote has been reset to the factory settings.

30PROGRAMMING THE REMOTE