Harman-Kardon AVR 110 20SYSTEM CONFIGURATION, Wand the PRO LOGIC indicator F lights up

System Configuration

To set the delay times, follow these steps:

1.Put the AVR 110 in the Dolby Pro Logic mode by pressing the Surround Mode Selector 7 on the front panel or by pressing the Surround Mode Selector j on the remote, until PRO LOGIC appears in the Main Information Display

Wand the PRO LOGIC indicator F lights up.

2.Press the Delay button 29 ñ on the remote or front panel. The words S DELAY TIME will appear in the Main Information Display W.

3.Press the Set button oï .

4.Adjust the delay time by pressing the

Ú/ Û buttons mq on the remote or the Selector buttons 5 on the front panel until the delay time figure calculated using the formula entered above appears in the display.

5.If only analog sources will be used, no adjustment is needed for the center-channel delay. In that case, press the Set button oï to enter the surround delay settings into the AVR 110’s memory. However, if you will be using digital sources and the calcu- lations outlined above indicate that the center-channel delay requires an adjust- ment, continue with the following steps.

6.Before setting the center-channel delay time, make certain that a digital source has been selected. If a digital source is playing, COAXIAL E or OPTICAL B will appear in the Information Display ó. If a digi- tal source is already connected and play- ing, press the Delay button ñ 29 and then the Ú/ Û buttons on the remote mqor the front panel Selector buttons 5until the words C DELAY TIME appear in the Main Information Display ó and proceed to Step 10. If a digital source is not playing, follow Steps 7 through 10.

7.Press the Set button oï.

8.Select the Dolby Digital mode either by pressing the front panel Surround Mode Selector 7or by pressing the Surround Mode Selector j on the remote on the remote until DOLBY DIG appears in the Main Information Display W.

9.Press the Delay button 29 ñ on the remote or front panel. The words S DELAY TIME appear in the Main Information Display W.

10.Press the Ú/ Û buttons mqon the remote once, so that C DELAY TIME appears in the Main Information Display

Wor in the on-screen display.

11.Press the Set button oï.

12.Press the Ú/ Û buttons mq on the remote or the Selector buttons 5 on the front panel until the desired delay time for the center channel appears in the display.

13.Press the Set button oï to enter the setting into the AVR 110’s memory.

You have now completed the setup, adjustment and calibration of the AVR 110. You are now ready to enjoy the finest in music and home- theater listening.

20SYSTEM CONFIGURATION