Cub Cadet 7264 manual Adjusting Front Wheel Toe-In

•The length of the upper hitch link is normally determined by the design of each implement. To adjust the upper hitch link, loosen the jam nut and turn the adjustment tube as shown in Figure 25. After the appropriate length is at- tained, tighten the jam nut. If correctly adjusted, the upper hitch link will be parallel or nearly parallel to the lower hitch links.

Lengthen

ADJUSTMENT TUBE

Shorten

JAM NUT

Figure 25

•The length of the hitch chains, attached to each lower hitch link, limit the side-to-side move- ment of the lower links. Loosen the jam nut and turn the chain’s hex shaft as shown in Figure 26 to adjust the length of the hitch chain. Tighten the jam nut after adjusting.

Turn Hex Shaft
to Lengthen
Loosen
Jam Nut	Turn Hex Shaft
	to Shorten

HEX SHAFT

HEX JAM NUT

Figure 26

ADJUSTING FRONT WHEEL TOE-IN

The front wheel toe-in is set at the factory and should maintain the proper setting. However, the toe-in should be checked periodically and readjusted if necessary.

CHECK THE TOE-IN AS FOLLOWS:

•Place the tractor on a level surface with the wheels in the straight ahead position.

•Place an easily visible mark on the center lines of both front tires at the horizontal center line of the wheel.

•Measure and record the distance ‘A’ between the two marks. See Figure 27.

•Roll the tractor forward or rearward until the marks are at the horizontal center line at the rear of the wheels. Measure and record the distance ‘B’ between the marks. See Figure 27.

•Distance ‘A’ should be 0"-.20" less than distance ‘B’ if the toe-in is correct. If it is not, readjust the toe-in.

A

B

Figure 27

READJUST THE TOE-IN AS FOLLOWS:

NOTE: The right ball joint and jam nut are left hand threaded.

•Loosen the jam nuts at both the LH and RH ball joints. See Figure 28.

•Using a pair of pliers (or similar tool) to grasp the tie rod, turn the rod as follows:

Forward to shorten the tie rod and decrease the toe-in. See Figure 28.

Rearward to lengthen the tie rod and increase the toe-in. See Figure 28.

Front of		Shorten Rod —
Tractor
		Decrease Toe-in
		Lengthen Rod —
		Increase Toe-in
		TIE ROD
		JAM NUT
	RH BALL JOINT

Figure 28

•Readjust the tie rod as necessary to obtain the correct toe-in, then tighten the jam nuts against the ball joints.

25