SAFETY INTERLOCK SYSTEM
This tractor is equipped with a safety interlock system for the protection of the operator. If the interlock system should ever malfunction, do not operate the tractor. Contact your authorized Cub Cadet Dealer. The safety interlock system prevents the engine from cranking or starting unless the brake pedal is fully depressed, and the PTO is “OFF”.
•The safety interlock system will shut off the engine if the operator leaves the seat before engaging the parking brake.
•The safety interlock system will shut off the engine if the operator leaves the seat with the PTO “ON”, regardless of whether the brake lock is engaged.
NOTE: The PTO switch must be moved to the “OFF” position to restart the engine. If the reverse override function had been activated, it will remain activated until the ignition switch is turned to the "OFF" position.
•The safety interlock system will shut off the PTO if the reverse control pedal is depressed, unless the reverse override function is activated.
FUELING THE TRACTOR
Fill the fuel tank with only clean, fresh, diesel fuel. Fuel with a cetane number of 45 is recommended, but fuel with a minimum cetane number of 40 is acceptable. To ensure the freshness of the fuel, purchase fuel in a quantity that can be used within 30 days.
NOTE: DO NOT USE KEROSENE OR GASOLINE in your diesel engine. Damage to the engine will occur.
Generally a good grade Number Two Diesel Fuel should be used in your diesel engine. However, in extremely cold temperatures a quality Number One Diesel Fuel, or a blend of Number One and Number Two Diesel fuels should be used. In most areas, diesel fuel is properly blended for seasonal use as ambient temperatures change. Therefore, it is important to monitor fuel purchases so that seasonal grade fuels are not carried over after the average ambient temperature has changed.
WARNING: Never fill the fuel tank to the top of the filler neck. Expansion could result in overflow through the vents in the cap, allowing fuel to come in contact with the operator.
•Do not smoke while refueling the tractor.
•Do not fill the fuel tank when the engine is running or while the engine is hot.
•The fuel fill cap is located on the fender to the left of the seat. Unscrew the fuel cap and fill tank from an approved container. Do not fill the fuel tank to capacity. Allow room for expansion.
•Tighten the fuel cap securely, and immediately wipe up any spilled fuel.
•To minimize condensation, keep the fuel tank as full as possible without filling to capacity. It is a good practice to fill the fuel tank at the end of the day to reduce overnight condensation.
•Do not allow the fuel tank to run dry. Running out of fuel requires bleeding air and repriming the fuel system.
WARNING: Fuel in the engine injection system is under high pressure. If not a qualified mechanic, do not attempt to service the fuel injection system. Do not use your hand to check for leaks.
NEW TRACTOR BREAK-IN PROCEDURES
Proper care during the first hours of operation will help to assure optimal performance from your new tractor.
•Never operate a new engine immediately under full load. Allow the engine to warm up.
•Avoid operating the engine for prolonged periods at either high or low speeds with no load.
•Use the transmission’s low speed range for heavy loads to avoid lugging of the engine due to overload.
•Closely monitor the engine oil and coolant levels, and keep filled to the recommended levels.
•After the first ten hours of operation, check all of the front and rear wheel bolts. If necessary, retighten to the following torque:
Front Wheels — 55 ft. lbs. Rear Wheels — 80 ft. lbs.
•Perform all
16
