Wheel drive control
Refer to the Adjustment section of the Assembly &
1.With the snow thrower tipped forward (be certain to run the fuel tank dry before tipping the unit forward), remove the frame cover underneath the snow thrower by removing the
Figure
2.Locate the opening between the axle support bracket and the front frame support (See Figure
3.With the wheel drive control engaged, the friction wheel must contact the drive plate. See Figure
4.If there is no friction wheel clearance, or the friction wheel does not solidly contact the drive plate,
5.Reassemble the frame cover.
Auger Control
Refer to the Assembly section for instructions on adjusting the auger control cable.
Tire Pressure
Refer to the Assembly section for instructions on adjusting the tire pressure.
Off-Season Storage
If the snow thrower will not be used for 30 days or longer, follow the storage instructions below.
1.Lubricate the machine as instructed earlier in this section.
2.Store in a clean, dry area.
3.If storing the snow thrower in an unventilated area, rustproof the machine using a light oil or silicone to coat the snow thrower.
4.Clean the exterior of the engine and the snow thrower.
IMPORTANT: See the Engine Operator’s Manual included with the snow thrower for complete engine
Friction
Wheel
| Axle | |
Drive | Support | |
Bracket | ||
Plate | ||
Opening | ||
|
Figure
Section 6 — Maintenance & Adjustments |
| 17 |
| ||
|
|
|