Service | 7 |
| |
|
|
Belt Replacement
Belt Removal Preparation
1.Disconnect the chute crank assembly at the discharge chute end by removing the hairpin clip and the flat washer.
Refer to Figure
Figure
2.Remove the hex screws and lock nuts securing the forward end of the support tubes to the back of the auger housing, and pivot the tubes upward.
3.Remove the plastic belt cover on the front of the engine by removing the three
Figure
4.Loosen the bolt shown in Figure
Remove
Loosen
Figure
Auger Belt Replacement
To remove and replace your snow thrower’s auger belt, proceed as follows:
1.Remove the hairpin clip and flat washer from the ferrule in order to disconnect the auger idler rod from the brake bracket assembly. See Figure
Figure
NOTE: Make sure to maintain the location of the ferrule on the idler rod.
18