Section 3

Shaft Grip

(4) Screws

 

Shaft

Housing

Minimum 6 inches

(15.24 cm)

D-Handle

Bottom Clamp

 

(4) Nuts

Fig. 3-1

(if used)

 

Fig. 3-2

Assembly

Install and Adjust the D-handle

1.Remove the screws and bottom clamp piece that were installed on the D-handle for shipping.

2.Place D-handle over the shaft housing and onto the bottom clamp (Fig. 3-1). Place it a minimum of 6 inches (15.24 cm) from the end of the shaft grip.

3.Start screws with a large Flat-head or T-25 Torx screwdriver. Do not tighten until you make the handle adjustment.

4.If it was pre-installed, loosen the screws on the D-handle just enough to move the D-handle.

5.While holding the unit in the operating position (Fig. 3-2), move the D-handle to the location that provides you the best grip.

6.Tighten the clamp screws evenly, until the D-handle is secure.

7