Section 3
Fitting the Bar & Chain
1
2
3
Check the chain tension frequently when operating the chain saw. Always use protective gloves.
With the engine off, follow the ensuing instructions:
•Pull the guard (Fig. 1) towards the front handle to check that the chain brake is not on.
•Remove the bar nuts (A) and the chain cover (B, Fig. 2).
•Remove and discard the plastic shim from the bar studs (C, Fig. 3).
•Take the chain tightener pawl (D, Fig. 3) to the limit stop, by unscrewing all the chain tightener screw (L).
•Place the bar (F, Fig. 3) onto the studs (N).
•Fit the chain (H, Fig. 4) inside the sprocket (E) and the bar groove (M).
NOTE: Pay attention to the direction of rotation of the chain (Fig. 6).
4
8
