Cub Cadet CS5720 manual Operation, Starting The Engine, Breaking-Inthe Engine, Section

Section 5

12A 12B

13

14

Operation

STARTING THE ENGINE

1.Fill the carburetor by pushing primer bulb (A) (Fig. 12B).

2.Put the ON/OFF switch (A, Fig. 12A) in the START position.

3.Pressing the push button (E, Fig. 14) opens the decompression valve. It will automatically close at the first start. We suggest to press the push button before every start.

4.Pull the throttle lever (B) and stop it at half-throttle by pressing the lever (C), then releasing the lever (B).

5.Pull the choke lever (D, Fig. 12A).

6.Place the chain saw on the ground in a stable position. Check that the chain is free to turn and will not come into contact with any foreign objects.

7.Hold the front handle firmly with your left hand and put your right foot onto the base of the rear handle (Fig. 13). Pull the starter rope slowly until you meet resistance, then pull it hard several times

8.When the engine starts, put the choke lever

(D, Fig. 12) back into its initial position. Repeat this until the engine starts.

9.Once the engine has started, press the throttle trigger (B, Fig. 12) to release it from the half-throttle position and let the engine idle.

NOTE: Once the engine is warmed up, do not use the choke to start up again.

Operate this unit only in a well-ventilated outdoor area. Carbon monoxide exhaust fumes can be lethal in a confined area.

Avoid accidental starting. Make sure you are in the starting position when pulling the starter rope (Fig. 13). To avoid serious injury, the operator and unit must be in a stable position while starting.

Use the half-throttle lever and other partial acceleration devices (from step 4) only when you are initially starting the engine.

BREAKING-IN THE ENGINE

The engine break-in period is approximately 20 hours.

During this period, avoid prolonged high-speed full throttle operation.

11