Assembly & Set-Up

3

 

Contents of Crate

 

•

One Zero-Turn Tractor

•

One Tractor Operator’s

•

One Deck Wash Hose Coupler

 

 

 

Manual

 

 

•

One Engine Operator’s Manual

 

 

 

 

Tractor Preparation

Remove the upper crating material from the shipping pallet, and cut any bands or tie straps securing the tractor to the pallet.

Use the lift handle to raise the deck to its highest position. Engage the transmission bypass rods on each side of the tractor; then carefully roll the tractor off the shipping pallet. The transmission bypass rods (one for each the RH and LH transmission) are located beneath the frame platform, just inside each rear wheel. Disengage the bypass rods. See Fig. 3-1.

Keyhole Slot

Transmission

Bypass Rods

2.Remove the two shoulder bolts, nuts and spacers securing the seat as shown in Fig. 3-2.

Nut

Bolt

Figure 3-2

3.Rotate the seat into position and secure the seat into place with the previously removed shoulder bolts, nuts and spacers. Be careful not to crimp or damage the wire harness while installing the seat. See Fig. 3-3.

Figure 3-1

Remove the deck wash system nozzle adapter and oil drain tube from the manual bag and store for future use. Cut the wire tie holding the chute deflector up and discard any packing material.

Install Operator’s Seat

To install the seat proceed as follows:

NOTE: The seat is shipped with the seat switch and seat pan attached.

1.

Cut any straps securing the seat assembly and the drive

 

 

 

 

 

Bolt

 

 

 

 

 

 

 

 

 

control levers to the tractor. Remove any packing material.

 

 

 

 

 

 

 

NOTE: Be careful not to cut the wiring harness connecting the

Nut

 

 

 

 

 

 

Spacer

 

 

 

 

 

 

 

 

 

 

seat and the seat switch in the bottom of the seat.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Wire Harness

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Figure 3-3

9