Cuisinart CPT-90C manual Cleaning Maintenance, Reheat Button

Reheat Button

Cancel Reheat Defrost

The Reheat feature allows you to reheat toasted bread without browning or toasting.

1. Insert slice(s) of bread:

Be sure that multiple slices do not overlap and the carriage is in the up position.

2.Set the Slice Control Switch to the

1Slice/2 Slice 1 2 or 3 Slice/4 Slice 3 4 position, as needed.

3.Press the Carriage Control Lever until it locks into position.

4.Press the Reheat Button.

You do not have to set the Browning Dial as this cycle will not brown or toast the bread.

To stop cycle:

When the Reheat Cycle is complete, the toaster will raise the bread. If you wish to stop the cycle before it is finished, simply press the Cancel Button to interrupt or lift up on the Carriage Control Lever. To remove toast, lift the Extra-Lift Carriage Control until it reaches its highest point. This is especially useful when toasting smaller breads.

CLEANING AND

MAINTENANCE

Always allow the toaster to cool completely before cleaning.

1.Always unplug the toaster from the electrical outlet.

2.Do not use abrasive cleansers. Simply wipe the exterior with a clean damp cloth and dry thoroughly. Apply any cleansing agent to a cloth, not to the toaster, before cleaning.

3.To remove crumbs, slide out the Crumb Tray and discard crumbs. Wipe clean and replace. Never operate the toaster without the Crumb Tray in place.

4.To remove any pieces of bread remaining in the toaster, turn the toaster upside down and gently shake. Never insert any hard or sharp instruments into the slot as this could damage the toaster and cause a safety hazard.

5.Never wrap the cord around the outside of the toaster. Use the cord storage cleats on the underside of the toaster.

FOR HOUSEHOLD USE ONLY

6