Cuisinart CSB-78 manual Cleaning, Hand Blender, Disposal/Recycling Of Batteries, Whisk attachment

Position the two mounting holes of the wall bracket over the screw heads, and slide wall bracket down the wall until the bracket is resting against the screw head, and will not slide any further. If the wall bracket feels too loose against the wall, remove bracket, put screws further into wall, and replace bracket.

Place the assembled hand blender into the wall bracket. The unit will hang from the bracket, held in place by the motor body width.

The charger handle can be attached to the motor body when you store the unit. This is especially helpful when you want the hand blender close at hand during a period of heavy use. At other times, keep the charger handle plugged into the electrical socket to assure the battery is always 100% charged.

CLEANING

Always clean the hand blender thoroughly after using.

Hand Blender

Detach the charger handle from the motor body before cleaning. Remove the shaft with the blade from the motor body. The shaft with the blade can be cleaned by hand in hot water with a mild detergent. It is not necessary to remove the blade from the shaft. Do not use abrasive cleansers which could scratch the surface.

Clean the motor body and the charger handle with a sponge or damp cloth only. Do not use abrasive cleansers which could scratch the surface.

The mixing/measuring beaker can be cleaned in the dishwasher (upper rack) or by hand in hot water with a mild detergent.

Never immerse the motor body or charger handle in water.

Chopper/Grinder Attachment

To simplify cleaning, rinse the prep bowl, cover and blade immediately after use, so that food won’t dry onto them. Wash blade ring, plastic sheath, and prep bowl in warm soapy water. Rinse and dry. Wipe the underside of the chopper/grinder cover with a sponge or damp cloth to remove any food. Do not submerge the cover in water or place in the dishwasher. Wash the blade carefully. Avoid leaving it in soapy water where

it may disappear from sight.

If you have a dishwasher, you can wash the prep bowl and blade assembly on the upper shelf. Insert the prep bowl upside down. Put the blade in the cutlery basket. Unload the dishwasher carefully to avoid contact with the sharp blade. Wipe the top cover with a damp sponge or cloth. Dry it immediately.

The chopper/grinder attachment is intended for HOUSEHOLD USE ONLY. Any service, other than cleaning and normal user maintenance, should be performed by an authorized Cuisinart Service Representative.

Whisk attachment

To clean your whisk attachment, simply release the attachment from the motor body housing. Once the whisk is removed, detach the metal whisk from the gearbox by pulling pieces apart. To clean the gearbox, simply wipe with a damp cloth. To clean the metal whisk, wash with warm, soapy water or place in the dishwasher. Do not submerge the gearbox in water or any other liquid.

DISPOSAL/RECYCLING

OF BATTERIES

This product uses four nickel-cadmium rechargeable and recyclable batteries. At the end of the batteries’ useful life, they should be recycled. These batteries must not be incinerated or composted.

Nickel-cadmium batteries should not be put in municipal waste systems. Contact your local waste collection agency for proper recycling and disposal information for your area.

Please do not attempt to dismantle the charger handle to replace these batteries on your own. Damage could result to the unit.

When it is time to replace and/or recycle the batteries, or to receive additional instructions for disposing of old batteries, call toll-free 1-800-726-0190 to order a new charger handle which will include the four new batteries. Or send the charger handle to Cuisinart, 150 Milford Road, E. Windsor, NJ 08520.

12