STORAGE STAND / WALL BRACKETS
The Cuisinart® Cordless Rechargeable Hand Blender includes a
Storage stand kit consists of six (6) pieces: two anchor bolts, two plastic wall anchors, and two storage pieces that can fit together for countertop, or be separated for wall mount.
Countertop Option
The two storage pieces fit together. (See diagram below.)
Align the two pieces back to back on a flat surface, with the
To store the hand blender, detach the shaft and place the bottom part (blade guard) into one of the reservoirs. Place the motor body (right side up) into the other reservoir. You should be able to read the Cuisinart® logo when the motor body is in the stand.
The charger handle can be attached to the motor body when you store the unit. This is especially helpful when you want the hand blender close at hand during a period of heavy use. Plug the charger handle into the electrical socket to keep the battery charged during other times. The counter storage unit can also be placed in a cupboard or on a shelf.
Wall Mount Option
Separate the two plastic storage stand pieces. You will need only one for wall mount. (See diagram on left.)
When selecting a mounting location, be sure to leave enough room above the storage stand for your hand to remove the Cuisinart® Cordless Rechargeable Hand Blender. Also be sure to leave enough room below the stand to allow the appliance to hang freely.
You will need to drill two holes 22/3" apart from each other, measured from the center of each hole. To assist in proper location of holes for the mounting screws, remove the wall mount template from this instruction book (page 13). Place the template over the back of the wall unit, aligning the outline of the template with the wall bracket. When
you have done this, place the template and wall bracket against the wall in the desired
location. Remove the wall bracket, leaving the template in place. Mark the wall with a pencil in the locations indicated for screw holes by the template. Remove the template.
With a drill, make a 3/16" starter hole for each screw. Place the plastic anchor in
each hole. Push completely into the
hole with fingers, or
tap in gently with a hammer. Screw a mounting screw into each hole, leaving 1/8" to ¼" of the head
and screw exposed.
11