2. Attach/Detach charger handle 2a. | Thumb |
to motor body. | grip |
a. After batteries are fully |
|
charged, remove charger | Push |
handle from wall socket. Push | |
down on thumb grip and slide | thumb |
the plug to the retracted | grip In |
position inside the housing. |
|
b. Press the release button. Align two slots on bottom
of charger with two tabs on 2b. top of motor body. Press together until you hear a
click and the two sections fit together without gaps.
c. To detach: Hold motor body |
| Press |
| release | |
firmly in one hand. Detach |
| |
| button to | |
charger handle by pressing |
| |
| separate | |
release button located at top |
| |
| or attach | |
of motor body, then pull char- |
| |
|
| |
ger handle away from motor |
|
|
body by lifting up with other |
|
|
hand. |
|
|
Note: Detach the changer handle from the motor body after each use.
Chopper/Grinder Attachment
E
JG
H
B 
IF
A 
C
D
A. Chopper/Grinder Prep Bowl
B. Cover Slots (3) for Attaching Cover
C. Metal Blade Assembly Shaft
D. Rubber Feet
E. Blade Assembly
F. Blade Ring
G. Plastic Blade Sheath
H. Chopper/Grinder Cover
I. Lift Tabs
J. Chopper/Grinder Spline
Reversible Blade
The Cuisinart® Cordless Rechargeable Hand Blender chopper/ grinder attachment is equipped with a reversible blade. This blade is sharp on one side and blunt on the other. The blade is attached to a plastic ring which slides over the blade assembly shaft, remove the blade to reverse edges, so it can be easily turned over to select the appropriate blade. To remove this blade twist in a counterclockwise motion. A guide for proper blade selection follows in the section, Frequent Uses
for Chopper/Grinder (page 9.)
Before you process any food, assemble the parts.
1.Place the prep bowl on a flat, dry, stable surface.
2.The metal blade assembly shaft is attached to the bottom
of the prep bowl. If not already in |
|
| |
place, slide the fully assembled |
| F | |
blade assembly over the top of the |
|
| |
blade assembly shaft. |
| K | |
To put together the blade assem- | N | ||
| |||
bly: Connect the blade ring (F) to the |
| G | |
plastic blade sheath (G). Line up the |
| ||
|
| ||
blade ring opening with the plastic |
|
| |
sheath. Let the blade ring slide to the |
|
| |
bottom of the plastic sheath. HOLD |
|
| |
THE BLADE RING BY THE CENTRAL |
|
| |
HUB HOLDING RIBS (grips) (K) |
|
| |
ONLY. DO NOT TOUCH THE |
|
| |
|
|
