Cuisinart EM-300 manual Programming a Custom Setting, Temperature Controls, Cleaning Maintenance

PROGRAMMING A

CUSTOM SETTING

At ready mode, hold and press MANUAL for 3 seconds to customize the SHORT and LONG output.

1. , , are ON. If no action within 30 seconds, unit returns to preheat/ ready mode.

--OR--

2.Press or button.

a. or LED remains on.

b.Espresso is dispensed.

c.When desired amount is dispersed into cup, press again. That will be the programmed amount.

d. or LED turns off and unit returns to preheat/

ready mode.

To reset to factory setting at ready mode, press and hold and at the same time

for 3 seconds.

1. ,and and LEDS flash 3 times.

2.Default setting is on and unit will return to preheat/ready mode.

TEMPERATURE

CONTROLS

Hot is the default setting. If Extra Hot is desired, press the button and allow less than 10 seconds for the temperature to rise. The

flashing light will turn steady when it has reached temperature.

Energy Saver Mode

After 30 minutes of non-use the espresso machine will automatically switch to sleep mode and all the control lights will be dimmed by about 50%. When any button is pressed, the espresso machine will return to

preheat mode and all the lights will flash. The machine is ready to operate when all the lights are steady again.

Auto-Off Mode Following the 30-minute Energy Saver cycle, if there is an additional 30 minutes of non-use, the espresso machine will turn off. Press the power button to turn on again.

CLEANING AND

MAINTENANCE

Cleaning External Parts

We recommend regular cleaning of the espresso makerÕs external components.

1.Never immerse the machine in water or other liquids. The housing and external parts may be cleaned with a soapy, damp, non- abrasive cloth.

2.To remove the drip tray, simply slide it toward you, keeping it level at all times in order to prevent spills. The drip tray and drip tray grate are dishwasher safe. Do not clean drip tray with cleansers, steel wool pads or other abrasive materials.

Cleaning the Water Reservoir

It is normal over time for discoloration, spotting or staining to appear in the water reservoir. Results will vary depending on the mineral content of the bottled or filtered water used but will not affect the operation of the machine. However, be sure to clean the water reservoir regularly to minimize build-up.

Clean inside the water reservoir with a damp, lint-free cloth as necessary.

Decalcification

Mineral content in water varies from place to place. Depending on the mineral content of the water in your area, calcium deposits or

7