Cuisinart HSM-70 manual Assembly, USE and Care, Cleaning and maintenance

Assembly

1..Attach hand mixer to stand

Line up the indent on the back end of the hand mixer with the tab in the back of the stand.. Place hand mixer on the stand with tab in indent and push the front of the hand mixer down onto the stand until it clicks into place..

2..Remove hand mixer from stand

Push down on hand mixer release button and lift the front end of the mixer off and up from the stand..

3..Raise stand head

Push down head lift release lever and raise stand head until it locks into place..

4..Lower stand head

Push down on head and fully lower the stand head until it clicks into place..

5..To place bowl on base

Line up grooves under bowl with the grooves on the base and it locks into place..

USE AND CARE

Inserting Beaters

1..Unplug mixer and set the power switch to the OFF position..

2..Insert beater with collar into the larger hole.. Push beater in until it clicks into place.. Insert the beater with the plastic padding on the end into the smaller hole.. Push beater in until it clicks into place..

Inserting Dough Hooks

1..Unplug mixer and set the power switch to the OFF position..

2..Insert dough hook with collar into the larger hole.. Push dough hook in until it clicks into place.. Insert the dough hook without the collar into the smaller hole.. Push dough hook in until it clicks into place..

Note:

Dough hook with collar will also have plastic padding on the end of the dough hook..

Larger

Hole

Inserting Chef's Whisk

1.Unplug mixer and set the power switch to the OFF position

2.Hold chef’s whisk at stem end, and insert into smaller hole.. Push whisk in until it clicks.. DO NOT PUSH WHISK IN FROM WIRE END, AS YOU MAY DAMAGE WIRES..

Turning Mixer On/Off

Plug mixer into outlet.. Press On/Off switch to turn mixer On.. Mixer will immediately begin to mix on Speed 1.. To turn mixer off, press On/Off switch again..

Changing Speeds

Press the + button on the digital touchpad to increase the speed.. Press the - button to decrease the speed..

Cleaning and maintenance

1..Unplug your Cuisinart® Hand Mixer before cleaning..

Hand Mixer

Release hand mixer from stand by pressing the hand mixer release button.. Then lift the beater release lever and remove the beaters from the mixer.. Wipe the hand mixer with a damp cloth or sponge.. Do not use abrasive cleaners, which could scratch the surface..

NEVER PUT THE MOTOR HOUSING IN WATER OR OTHER LIQUID TO CLEAN..

Bowl

If hand mixer is not on the stand, lift bowl from base.. If hand mixer is on stand, raise the stand head using the head-lift release lever and then remove bowl from base.. Wash the bowl by hand and dry thoroughly or put in dishwasher.. Never use a wire brush, steel wool or bleach..

Stand

Wipe with a damp cloth and dry.. Never use abrasives or immerse in water..

Turntable

NOTE: It is not recommended to take turn- table off stand.. To clean, remove bowl and hand mixer from stand.. Wipe down turn- table or wash by hand..