
QUICK SETUP GUIDE: PART 1
IMPORTANT!
Do not throw away. Read before operating your new
water filtration system. Keep for further reference.
This setup guide is intended to be a supplement to the Instruction Booklet. In order to ensure proper
setup, safe operation and optimum performance, please read the entire Instruction Booklet.
You will need a large bowl, a pitcher (or another type of container) and a glass
to complete this setup. Do not plug in unit until ALL steps of SETUP are complete.
WATER FILTER PREPARATION
1.
Remove filter from packaging. DO NOT WASH FILTER.
Press filter firmly to the bottom of an empty bowl sideways. Slowly submerge with cold water to cover by 1" and hold under water for 30 seconds.
2. | Release filter and let soak for at |
least 15 minutes. The filter | |
should be partially submerged |
and may tilt to one side.
While filter is soaking, remove filter timer from lid
and wash lid and both tanks
with warm, soapy water. Replace timer.
| WATER FILTER INSTALLATION |
3. | 4. |
With Cuisinart® | Place upper |
logo facing | water tank on a |
up, insert filter | pitcher (or |
into upper | another type of |
water tank | container) and |
and push | fill with cold |
firmly into | water. Let drain |
place. | for 5 minutes, |
| then discard |
| remaining water. |