Curtis iP3019UK instruction manual Wall or Ceiling Mounting

SAFETY INSTRUCTIONS

16.OUTDOOR ANTENNA GROUNDING

If an outside antenna is connected to the prod- uct, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electric Code, ANSI/NFPA70, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna dis- charge product, size of grounding conductors, location of antenna discharge product, connec- tion to grounding electrodes and requirements for grounding electrodes.

	ANTENNA
	LEAD IN
	WIRE
	GROUND
	CLAMP
	ANTENNA
	DISCHARGE UNIT
	(NEC SECTION 810-20)
ELECTRIC	GROUNDING CONDUCTORS
SERVICE
EQUIPMENT	(NEC SECTION 810-21)
	GROUND CLAMPS
	POWER SERVICE GROUNDING
NEC - NATIONAL ELECTRICAL CODE	ELECTRODE SYSTEM
	(NEC ART 250, PART H)

S2898A

EXAMPLE OF ANTENNA GROUNDING AS PER

NATIONAL ELECTRICAL CODE

17.SERVICING

Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

18.REPLACEMENT PARTS

When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards.

19.SAFETY CHECK

Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

20.WALL OR CEILING MOUNTING

The product should be mounted to a wall or ceil- ing only as recommended by the manufacturer.

21.DAMAGE REQUIRING SERVICE

Unplug the product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power-supply cord or plug is damaged.

b.If liquid has been spilled or objects have fallen into the product.

c.If the product has been exposed to rain or water.

d.If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.

e.If the product has been dropped or the cabinet has been damaged.

f.When the product exhibits a distinct change in performancethis indicates a need for service.

22.HEAT

The product should be situated away from heat sources such as radiators, heat registers, stoves or other products (including amplifiers) that pro- duce heat.

23.NOTE TO CATV SYSTEM INSTALLER

This reminder is provided to call the CATV sys- tem installer's attention to Article 820-40 of the NEC that provides guidelines for proper ground- ing and, in particular, specifies that the cable ground shall be connected to the grounding sys- tem of the building, as close to the point of cable entry as practical.

4