Curtis SRCD-4400 instruction manual Remote Control, Operating Instructions, Control Locations

Remote Control

OPERATING INSTRUCTIONS

Control Locations

LISTENING TO THE RADIO

1

2

3

22
	MEMORY
23	PRESET
	-UP
24	28
25	STOP

Set the VOLUME Control to a low	Slide the POWER Switch to the ON	Press the BAND Button to a
setting.	position. And Slide the FUNCTION	desired setting - AM, FM.
	Switch to the RADIO position.	NOTE: If you select either the
		FM or FM Stereo bands, be sure
		to raise the FM rod antenna and
		extend it to its full length.

26	27
ST./MO/	BAND
REPEAT

PLL REMOTE CONTROL

SRCD-4400

4

1

2

5
FM	MHz
	ST

6

22.MEMORY Button

23.CD PLAY/PAUSE/PRESET-UP Button

24.CD Skip/Reverse ( ) Button

25.STOP Button

26.FM Stereo/Mono/CD REPEAT Button

27.BAND Button

28.CD Skip/Forward ( ) Button

Install battery

1.Open the battery cover to remove it.

2.Insert two AAA batteries (not included) correctly so that the + and - polarities match the polarity diagrams inside the battery compartment.

Note:

*About half a year of normal operation can be expected when using the general batteries.

*When the batteries are exhausted, the commander should no longer operate the system. Replace both batteries with new ones.

*When the commander is not to be use for a long time, remove the batteries to avoid damage caused by battery leakage and corrosion.

*Avoid keeping the commander in extremely hot or humid locations.

,,

*Between remote controller and remote sensor there should be no obstacle and have to within 30 range.

*The remote controller,s operating distance is about 0.2M to 6M away from the remote sensor.

Press the TUNING-Up Button 1 or	If the BAND Switch is set	When you have finished listening,
TUNING-DOWN Button 2 to find	to the FM STEREO positing and	Slide the POWER switch to
the desired station.	you have tuned to an FM Stereo	the OFF position to shut the power
	station, the FM STEREO LED	off.
	Indicator will light.

Hints for Better Reception

FM - Make sure that the telescopic FM Rod Antenna is raised and extended to its full length. You may

have to vary the direction of the antenna to find the strongest signal for each FM station. If you are listening to weak or distant FM Stereo station and reception is unsatisfactory, press the ST/MONO button to the FM (Mono) on the remote control . This will normally provide an improvement in reception, although the sound will no longer be in stereo.

AM - The AM ferrite bar antenna is located inside the cabinet. It may be necessary to turn the unit slightly so that the internal antenna is point in the direction of the AM transmitter. You may have to experiment to find the position that provides the strongest reception for each of your favorite AM stations.

-6- -7-