DC Fuse Replacement (For Cigar Plug Cable)
The CPS480PAU inverter contains a fuse inside in the cigar plug (see Figure 1) to protect the unit against overloading. If the inverter draws more than 150 watts, the internal fuse may open to protect the inverter, vehicle battery, and the connected equipment. To replace the fuse, please follow the instructions below:
1.Unplug the inverter from the power source.
2.Remove the contact retainer from the 12V DC adapter.
3.Replace the 15 amp fuse.
4.Reassemble the fuse, contact pin, and contact screw carefully.
5.Ensure all pieces shown in Figure 1 are installed in the correct sequence.
| Spring |
12V DC Adapter | Decorative Ring |
| |
| Contact Pin |
15 ampFuse | Contact Retainer |
Figure 1. Fuse Replacement
Specifications
Model | CPS240PAU | CPS480PAU | |
Input Voltage | 11 to 15 volts | ||
Output Peak Power | 240 Watts | 480 Watts |
|
Output Continuous Power | 200 Watts | 400 Watts | |
Output Voltage |
| 120 Volts |
|
Output USB Voltage |
| 5 Volts |
|
Output Frequency |
| 60 Hz |
|
Output Waveform | Simulated Sine Wave |
| |
Input Fuse (Internal) | 25Amp | 25Amp x2 |
|
Input Fuse (Cigar plug) | 15Amp (CPS480PAU only) |
| |
Protection Features | Overload, Overvoltage, |
| |
| Overheating, | ||
Troubleshooting
Problem | Possible Cause | Suggested Solutions | |
|
|
|
|
No AC output - | 1.DC input is below 11 | 1.Check your battery volts | |
Red LED lit. | Vdc / Over 15Vdc | and recharge or replace the | |
| 2.Short circuit. | battery. | |
| 3. Overload | 2. Disconnect the load. | |
| 4. Inverter hot. | 3. Reduce the load. | |
|
| 4. Disconnect the load and | |
|
| operate the inverter for a | |
|
| few minutes. | |
No AC output - | 1.Bad connection or | 1.Tighten all DC connections. | |
Green LED not | wiring |
|
|
lit. | 2.Fuse is blown | 2.Check fuse and replace or | |
|
| Call Service | |
Motorized power | Excessive startup load. | Disconnect the load until the | |
tool will not | If the start up load | inverter operates normally | |
operate | exceeds the inverters | and connect the load again. | |
| peak load capability it |
|
|
| will not work. |
|
|
Limited Warranty | Note Page |
CyberPower warrants this CPS240PAU / CPS480PAU (the "Inverter") to be free from material and manufacturing defects for two years. If a defect results in product failure during its normal use, CyberPower’s sole responsibility is to repair or replace (at its sole option) the Inverter.
The foregoing Limited Warranty is the consumer’s sole and exclusive remedy and excludes any incidental or consequential damages. Some States do not allow the exclusion or limitation of incidental and consequential damages, so certain of the above limitations or exclusions may not apply to you (the Consumer). This limited warranty gives the Consumer specific legal rights and the Consumer may have other rights, which vary from State to State.
To make a Limited Warranty claim:
1.Pack and ship the Inverter to CyberPower at 4241 12th Avenue East, Suite 400, Shakopee, MN 55379.
2.Clearly indicate on the outside of the packaging that this is a “WARRANTY RETURN”
3.Clearly include your name and address (a) on the outside packaging and (b) on a sheet of paper enclosed in the box with the Inverter that is being returned.
4.You MUST prepay all shipping costs and you are responsible for packaging and shipment.
CAUTION: Any changes or modifications not expressly approved by the guarantee of this device could void the user’s authority to operate the equipment.
Product Registration
Thank you for purchasing a CyberPower product. Prompt product registration entitles coverage under the Limited Warranty and also allows the opportunity to be notified of product enhancements, upgrades, and other announcements.
Registration is quick and easy at www.cpsww.com/register
Technical Support
Feel free to contact our Tech Support department with installation, troubleshooting, or general product questions.
CyberPower Technical Support
Phone:
Email: tech@cpsww.com
Web: www.CPSww.com
Address: 4241 12th Ave. E., STE 400, Shakopee, MN 55379
Hours of Operation: Monday – Friday, 7:00am – 6:00pm (CST)
Legal notices (FCC Part 15)
This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio/TV technician for help. Any special accessories needed for compliance must be specified in the instruction.
CAUTION: A
CyberPower Systems (USA), Inc.
4241 12th Avenue East, Suite 400, Shakopee, MN 55379
TEL: (952)
FAX: (952)
CPSww.com
C2014 CyberPower Systems, Inc.
All rights reserved. Reproduction in whole or in part without permission is prohibited.
