![](/images/new-backgrounds/1193673/1936735x1.webp)
CPS1250AVR
Guaranteed Uninterruptible Power System
DESCRIPTION
1. Power on Indicator
This LED is illuminated when the utility condition is normal and the UPS outlets are providing “clean power”, free of surges and spikes
2. Electrical Wiring Fault Indicator
This LED indicator will illuminate to warn the user that a wiring problem exits with the AC outlet, such as bad ground, miss ground or reversed wiring. If this is illuminated, the user is advised to disconnect all electrical equipment from the outlet and have an electrician check the outlet to insure proper wiring.
3. AVR Indicator
This LED indicates that the UPS is operating in automatic voltage regulation mode.
4. Using Battery
This illuminates during utility failure, indicating that the battery is supplying power to the
5. Check Battery
This illuminates indicating a weak battery. If the indicator is still illuminated after allowing the unit to charge for 12 hours, replace the battery according to the instructions in the Replacing the Battery section of this manual.
6. Power Switch
Can be used as a master on/off switch for equipment connected to the battery power supplied outlets.
7. All outlets Designed for AC Adapters
Allows six AC power adapter blocks to be plugged into the UPS without making adjacent outlets inaccessible.
8. Communication Protection Ports
Communication protection ports will protect any standard modem, fax machine or telephone.
9. Serial Port to PC
This port allows connection and communication from the
10.
All outlets on the unit provide surge suppression for connected equipment.
11.
The circuit breaker provides circuit overload and fault protection.
12. Battery Power Supplied Outlets
Provides three
INSPECTION
The box should contain the following:
(1)PowerPanel Plus™ software (floppy disk); (1) serial interface cable
HOW TO DETERMINE THE POWER REQUIREMENTS OF YOUR EQUIPMENT
1.Make sure that the total
2.Insure that the equipment plugged into the three battery
3.If the power requirements of your equipment are listed in units other than
TO ESTIMATE POWER REQUIREMENTS:
Watts (W) x 1.82 = |
| VA or |
| Amps (A) x 120 = |
| VA |
Add the totals up for all pieces of equipment and multiply this total by .6 to calculate actual requirements.
There are many factors that can affect the amount of power that your computer system will require. The total load that you will be placing on the
1