CyberPower Systems CPS3000PIE user manual Fault Warning Display And Alarm, Condition, Solution

CPS3000PIE

Step 3: Press and hold the toggle for 4 seconds. When the icons blink, the value of each item can be changed by slightly pressing the toggle.

Step 4: To save the value and return to general mode, press and hold the toggle for 4 seconds.

Note: If the machine is left idle for over 30 seconds during setup, it will turn off the backlight and return to general mode automatically.

Note: If user wants to return to general mode without saving changes, there are two methods:

1.Wait for the backlight to turn off

2.Press and hold the “Display” toggle for 10 seconds

FAULT WARNING DISPLAY AND ALARM

1.Overheat Protection：

zEPS overheat：The output of the machine is removed and the LCD display shows the temperature exceeds 70℃ (157℉). FAULT Icon lights as well.

2.Over-voltage Protection：The output of the machine is removed. Over Load and FAULT Icon lights on the LCD display.

3.Battery Missing：A long beep is heard and Battery Icon flashes。

4.The following table shows each corresponding warning message on the LCD display and the alarm action when the machine output is off：

		Condition	Solution
LCD Warning	Alarm
Display
Fault Icon	Rapid Beep	High Temperature	Check fans function and
>70		Output-Off	air vent clearances.
		Over 70℃
Over Load Icon.	Long Beep	Over Load Output-Off -	Check total load to
Fault Icon		Load exceed the rating of	confirm the rating of EPS.
		EPS.

11