CyberResearch® CPU Cards

CPBH Series

Chapter 3

Hardware Installation

This chapter provides the information on how to install the hardware using the CPBH. This chapter also contains information related to jumper settings of switch, watchdog timer selection, etc.

3.1Before Installation

After confirming your package contents, you are now ready to install your hardware. The following are important reminders and steps to take before you begin with your installation process.

1.Make sure that all jumper settings match their default settings and CMOS setup correctly. Refer to the sections on this chapter for the default settings of each jumper. (Set JP3 1-2)

2.Go through the connections of all external devices and make sure that they are installed properly and configured correctly within the CMOS setup. Refer to the sections in this chapter for the detailed information on the connectors.

3.Keep the manual and diskette in good condition for future reference and use.

4.Make sure your power supply is you use is for P4 only. One of 4-pin connectors is for +12V lead which should be connected to CN1 connector of the CPBH.

CyberResearch, Inc.

7

25 Business Park Drive

P: (203) 483-8815; F: (203) 483-9024

Branford, CT USA

www.cyberresearch.com