D-Link DES-1016D Hub without Uplink (MDI-II) port

10/100 NWay Ethernet/Fast Ethernet Switch User’s Guide

Connecting The Switch 13

For a 10BASE-T hub, the Switch’s LED indicators should

illuminate the following:

♦ 100Mbps LED speed indicator is OFF.

♦ Link/Act indicator is ON.

For a 100BASE-TX hub, the Switch’s LED indicators should

illuminate the following:

♦ 100Mbps LED speed indicator is ON.

♦ Link/Act is ON.

Hub without Uplink (MDI-II) port

If a hub is not equipped with an Uplink (MDI-II) port, then a

connection can be made using either straight cable or crossover

cable (see Appendix B, Pin Specification for cable requirement).

Contents

Main Wichtige Sicherheitshinweise Limited Warranty Hardware: Software: D-Link Offices for Registration and Warranty Service LIMITATION OF WARRANTIES LIMITATION OF LIABILITY Page TABLE OF CONTENTS Page 0 ABOUT THIS GUIDE Purpose Terms/Usage Overview of this Users Guide Page 1 INTRODUCTION Features Performance features 2 UNPACKING AND S Unpacking Setup Desktop or Shelf Installation Rack Installation Power on Page Page Rear Panel LED Indicators Page 4 CONNECTING THE S Switch to Hub (with Uplink) 10BASE-T Hub 100BASE-TX Hub Hub without Uplink (MDI-II) port Page Technical Specifications 15 A 5 TECHNICAL S General 16 Technical Specifications General Physical and Environmental Performance Page B 6 RJ-45 PIN S Page Page Offices Registration Card Product was purchased from: