Port Speed & Duplex Mode | D-Link DES-1108 instruction

Section 2 - Installation

Port Speed & Duplex Mode

After plugging the selected cable to a speciﬁc port, the system uses auto-negotiation to determine the transmission mode, auto-detecting the network speed (10Mbps or 100Mbps) for any new twisted-pair connection.

If the attached device does not support auto-negotiation or has auto-negotiation disabled, an auto-sensing process is initiated to select the speed and half-duplex mode is selected.

D-Link DES-1108 User Manual

11

Image 11

D-Link DES-1108 manual Port Speed & Duplex Mode

Contents

Page Table of Contents ProductPackageOverviewContents Fast Ethernet Technology Switching TechnologyIntroduction Product Overview Features Product Overview Link/Activity PowerHardware Overview Front Panel LEDs Auto MDI/MDI-X Ports DC Power JackRear Panel Connections Connecting the Switch Installation Port Speed & Duplex Mode Mounting on a wood wall Mounting the Switch on the WallMounting on a cement wall What is Store-and-Forward switching? TroubleshootingDoes the DES-1108 switch have an uplink port? Check your IP address Networking Basics Step Highlight Internet Protocol TCP/IP and click Properties Step DES-1108 Speciﬁcations Technical Speciﬁcations FCC Class B, CE Class B MAC Address Learning Automatic updateRJ-45 Connector pin assignment RJ-45 Pin Speciﬁcations Phone Support Contacting Technical Support Limited Warranty Warranty Non-Applicability of Warranty Limited Software Warranty Disclaimer of Other Warranties What Is Not Covered Copyright Statement Limitation of LiabilityGoverning Law Trademarks FCC Statement CE Mark Warning Registration