Speed/Disable, Flow Control, Default Priority | D-Link DGS-1216T

2.The priority of Gigabit Fiber port is higher than Copper.

To change the port setting, click on the ID parameter to enter to the selected port to configure its Speed/Disable and Flow control setting.

Figure 18.

Speed/Disable:

This setting has six modes—100M Full, 100M Half, 10M Full, 10M Half, Auto and Disable—for speed or port disable selections.

Flow Control:

This setting determines whether or not the Switch will be handling flow control. Set FlowCtrl to Enable for avoiding data transfer overflow. Or it sets to Disable; there is either no flow control or other hardware/software management.

When the port is set to forced mode, then the flow control will automatically set to Disable.

Default Priority:

29

Image 35

D-Link DGS-1216T manual Speed/Disable, Flow Control, Default Priority

Contents

Building Networks for People LinkDGS-1216TPage Table of Content Page Technical Specifications Iii Page Terms/Usage PurposePage Introduction Gigabit Ethernet Technology Fast Ethernet Technology Switching Technology Vlan Virtual Local Area Network FeaturesPage Page Unpacking Installation Attach the adhesive rubber pads to the bottom Rack Mounting AC Power Connecting Network CablePage Mini Gbic Ports LED IndicatorFront Panel Gigabit Ethernet Ports Port 1~16 Rear Panel AC Power ConnectorReset Understanding LED Indicators Power and System LEDs Link/ACT Link/Activity Ports 1~16 Status LEDs Network, the Link/ACT LED lights on Configuration Installing the Web Management Utility Web Management Utility Discovery List System word definitions in the Monitor List Monitor ListSystem word definitions in the Discovery List Trap information Configuration Setting Device Setting Toolbar Firmware upgrade Configuring the Switch Login Device Status Setup Menu Setup menu Port Settings Configuring Setup Setting Flow Control Speed/DisableDefault Priority Page Port VID Setting Vlan Settings Virtual Local Area Network Mirror Setting Trunk Setting Spanning Tree Setting Ieee 802.1P QoS Setting Spanning Tree Setting Snmp Setting MIBs Traps Snmp Community Setting Configure Snmp Community Delete Snmp Community group Configure Snmp Trap Setting Configure Snmp Trap Delete Snmp Trap Device Status Jumbo Frame Setting Device statistic Statistic System setting System Setting Trap Setting Trap Setting Set Password Abnormal* 50 error packet count within 10 seconds Reset Setting Backup Setting Logout Logout Technical Specifications Performance Page Page Product Registration International Offices Registration Card All Countries and Regions Excluding USA