D-Link DSL-302T user manual Information Required for Installation

DSL-302T DSL Modem User’s Guide

Information Required for Installation

Information you will need from your ADSL service provider:

	This is the Username used to log on to your ADSL	Record info here
Username	service provider’s network. It is commonly in the form −
	user@isp.com. Your ADSL service provider uses this
	to identify your account.
	This is the Password used, in conjunction with the
Password	Username above, to log on to your ADSL service
	provider’s network. This is used to verify the identity of
	your account.
	This is the method your ADSL service provider uses to
	send and receive data between the Internet and your
Connection Protocol	computer. Your Modem supports the following
	connection protocols: PPPoE, PPPoA, CLIP (IPoA) and
	Bridge.
	This is the method your ADSL service provider will use
Security Protocol	to verify your Username and Password when you log
	on to their network. Your Modem supports the PAP and
	CHAP protocols.
	This is the Virtual Path Identifier (VPI). It is used in
VPI	conjunction with the Virtual Channel Identifier (VCI)
	below, to identify the data path between your ADSL
	service provider’s network and your computer.
	This is the Virtual Channel Identifier (VCI). It is used in
VCI	conjunction with the VPI above to identify the data path
	between your ADSL service provider’s network and
	your computer.

Information you will need to change settings on the DSL-302T Modem:

	This is the Username needed access the Modem’s	Record info here
Username	management interface. When you attempt to connect to
	the device through a web browser you will be prompted
	to enter this Username. The default Username for the
	Modem is admin. This may be changed by the user.
	This is the Password you will be prompted to enter
Password	when you access the Modem’s management interface.
	The default Password is admin. This may be changed
	by the user.
	This is the IP address you will enter into the Address
	field of your web browser to access the Modem’s
	configuration graphical user interface (GUI) using a
LAN IP addresses for	web browser. The default IP address is 192.168.1.1
	and it is referred to as the “Management IP” address in
the DSL-302T
	this User’s Manual. This may be changed to suit any IP
	address scheme the user desires. This address will be
	the base IP address used for DHCP service on the LAN
	when DHCP is enabled.
LAN Subnet Mask for	This is the subnet mask used by the DSL-302T, and
	will be used throughout your LAN. The default subnet
the DSL-302T
	mask is 255.255.255.0. This can be changed later.
	x