Computer to Router Connection
You can connect the Router directly to a
Power On Router
To power on the Router:
1.Insert the AC Power Adapter cord into the power receptacle located on the rear panel of the Router and plug the adapter into a suitable nearby power source.
2.You should see the Power LED indicator light up and remain lit. The Status LED should light solid green and begin to blink after a few seconds.
3.If you have the Router connected to your network you can look at the Ethernet Link/Act LED and WLAN indicators to make sure they have valid connections. The Router will attempt to establish the ADSL connection, if the ADSL line is connected and the connection is properly configured this should light up after several seconds.
Factory Reset Button
The Router may be reset to the original factory default settings by depressing the reset button for a few seconds while the device is powered on. Use a ballpoint or paperclip to push down the reset button. Remember that this will wipe out any settings stored in flash memory including IP settings. The factory default IP address of the Router is 192.168.1.1 and the subnet mask is 255.255.255.0.
11
