Dacor ACS273, ACS303 manual Replacing the Oven Lights, To replace a light bulb, follow these steps

Lens Cover

Figure 22 Oven Light Assembly

CARE AND CLEANING

Adjusting the Oven Temperature (Continued)

IMPORTANT

The user may find the temperature in their new oven to be different from that of their previously-owned appliance. Familiarity with the old appliance sometimes makes it difficult to get used to a new oven. If you feel that the oven temperature is consistently high or low, the temperature of the new oven can be adjusted. The adjustment needs to be done only once.

The oven temperature may be adjusted (calibrated) by following these steps:

1.Press “BAKE” selector pad.

2.Press the “TIME•TEMP” “+” pad to set a temperature of 500˚F or higher.

3.Press and hold the “BAKE” selector pad. After approximately 5 seconds the temperature display is replaced by “00”. The “BAKE”

pad cannowbereleased.Thecalibrationmodehasbeenaccessed.

Figure 21 Clock Display When Adjusting (Calibrating) the Oven

Temperature

4.Press the “TIME•TEMP” “+“ or “–” pad to set the amount of temperature

adjustment. The temperature can be changed a maximum of 35˚F higher or lower. Set the adjustment to positive (+) numbers to increase the oven temperature; set the adjustment to negative (–) numbers to reduce the oven temperature. Temperatures can be adjusted in increments of 5˚F.

5.After setting the desired temperature adjustment, press the “CANCEL•SECURE” pad to exit the calibration mode and to reset the clock display.

NOTES:

1. If “CANCEL•SECURE” is not pressed after setting the adjustment, the clock display will automatically reset in 6 seconds.

2.The amount of temperature adjustment may be changed again by repeating the calibration procedure. The oven will only retain the amount of the most recent temperature adjustment.

3.The temperature adjustment is not affected by an electrical power failure

4.The temperature adjustment only affects Standard Bake and Convection Bake modes. Broil and Self-Clean temperatures cannot be adjusted.

Replacing the Oven Light(s)

The light assembly consists of a removable lens cover and 10-watt 120VAC halogen bulb, as well as a light fixture housing. Light bulb replacement is considered to be a homeowner maintenance operation.

WARNINGS:

To prevent electrical shock and/or personal injury:

1.Make certain that the appliance and light bulb are cool and that power to the appliance has been turned off before replacing the light bulb.

2.Always ensure that the lens cover is in place when using the appliance. The lens cover protects the bulb from breakage caused by high temperatures or mechanical shock.

To replace a light bulb, follow these steps:

1.Turn off the power at the main power supply.

2.Remove the lens cover from the housing by pulling straight out.

NOTE:

In some cases the lens cover may be tight enough to require the use of your light lens pry stick. This prying tool should be used with caution. Do not cause uneven stress on the lens cover. Gently insert the point end of the pry stick under the center edge of the

lens cover on the side facing the oven door. Hold your hand under the lens for support then pry out to remove the lens cover.

3.Pull the light bulb out and replace it with a special 10-watt halogen bulb rated for use in a Self-Cleaning oven. Use DACOR Part No. 86364 available from any authorized DACOR parts distributor or dealer.

4.Reinstall the lens cover by aligning the cover over the opening and gently pressing it into its original position.

5.Turn the power back on at the main power supply.

14