Installation Instructions
4.Check for leaks under the dishwasher and under the sink. If any leaks are found, immediately push the STOP button and disconnect power. If there are leaks under the sink, check the water supply and drain connections. Reconnect power and restart the cycle. If the leak is elsewhere, and
a hose extension is installed, check for a loose connection.
5.If the dishwasher functions normally, complete the installation as instructed on the following sections.
If the dishwasher fails to operate properly:
•Verify that power is supplied to the dishwasher.
•Check all plumbing connections.
•Check for kinks in the water supply line and the drain hose.
•Repeat the Wet Test Checklist.
•If the appliance still does not work, contact Dacor Distinctive Service at (877)
Dacor is not responsible for the cost of correcting problems caused by a faulty installation.
Final Leveling
1.Check to make sure that adjacent drawers and cupboards can be opened when the dishwasher door is open. Reposition the dishwasher if necessary.
2.Check that there is a 1/8” (3.0 mm) space between the top of the dishwasher door and the underside of the cabinet.
1/8” (3.0 mm)
3.If necessary adjust the front leveling legs until the dishwasher is the correct height. Both front legs must contact the floor solidly.
4.Check to make sure the unit is level side to side and front to back. Also check to make sure both front legs are contacting the floor securely. Readjust the leveling legs as necessary. NOTE: The unit may have an inclination of 3/16” (5.0 mm) maximum without affecting performance.
5.Once level, hand tighten the front leg retaining nuts. Tighten them into place using a crescent wrench.
12 
