Installation Instructions

Attaching the Anti-tip

Brackets

CAUTION

Make sure to anchor one anti-tip bracket on each side of the dishwasher.

1.The anti-tip brackets protect against possible tipping caused by heavy bottom rack loads on the door. Use only the stainless steel screws provided with the machine.

2.Open the door and remove the top rack. Pull the rack out. Turn both rack stops outwards on the rack mounting rails (see diagram). Pull the rack toward you to remove.

Rack

stop

3.The anti-tip brackets may be secured either through the top or the sides. Installations with a hard material (like granite) may require attachment through the sides.

4.When installing the screws, place the included spacer over the screw. Insert the screws into the holes in the anti-tip brackets through the access holes in the top or sides of the door jamb as shown below. Tighten the screws in place.

5.Replace the top rack.

Attachment methods

Anti-tip bracket

or

Installing the Toe Kick

1.Loosen the brackets for the toe kick by moving the gray catches toward the center of the dishwasher.

Catch

Toe kick bracket

2.Adjust the brackets (pull out or push in) until they are flush with the kitchen toe kick on both sides as shown below.

3.Lock the brackets in place by pushing both catches into the appropriate notch in the holder.

4.Hang the toe kick on the brackets as shown. Check to make sure that the toe kick is even with the kitchen cabinet toe kick. If necessary, remove the toe kick and readjust the brackets.

continued...

Access

Screw Spacer hole

13