Installation Instructions
Hanging the Range Hood
warning
Hanging the range hood requires two people. Do not attempt to lift the hood without assistance.
1.Remove the filters from the bottom of the hood to reduce the chance of damage during installation. Put them in a safe location.
2.Remove the plastic coating from the outside of the hood.
3.Lift the hood into its final position and hold it in place.
4.While holding it in place, mark the desired locations for the anchors or wood screws through the mounting slots on the back and top of the hood.
Back holes
Top
holes
5.Remove the hood from the wall.
6.Drill the pilot or mounting anchor holes. If using mount- ing anchors insert them into the mounting holes.
7.Lift the hood again into its final position and fasten it in place. Insert the fasteners through the mounting slots in the back and top of the hood into the studs, mount- ing blocks or anchors.
Ductwork Installation
warning
During duct installation, make sure there are no obstructions that keep the damper flaps on the top of the hood from opening.
•Install the ductwork starting from the hood, working toward the outside vent. Observe the specifications on page 5.
•Fasten all joints with sheet metal screws and seal with duct tape or certified silver tape.
Final Electrical Installation
warning
•To avoid electric shock or fire hazard, prior to connect- ing the electrical wiring to the hood, make sure that power to the hood power supply line is turned off at the fuse box or circuit breaker panel.
•Improper connection of the hood electrical wiring may create an electric shock or fire hazard and may result in damage to the hood’s electrical system. See page 4 for specifications.
•Do not ground the hood to the neutral (white) power supply wire. Connect the hood ground wire to a sepa- rate, properly grounded wire installed by a licensed electrician.
•Make sure all wire used is capable of handling the total connected load. See page 3.
1.Turn off power to the electrical circuit that will supply the hood at the circuit breaker or fuse box.
2.Feed the end of the hood wiring harness through the wiring access hole as shown.
Wiring harness 
8