Care and Cleaning

Removing your oven’s convection filter...

When the oven is cool, put your fingers around the edges of the filter and gently push up.

1

To clean the filter...

Soak it in hot, soapy water. Rinse well. You may also place it in a dishwasher on the top rack. Dry the filter before re-installing it.

Installing your oven’s convection filter...

Carefully hook the metal clips on the back of the filter on the slots on both sides of the fan hole. Be careful not to scratch the porcelain surfaces with the back of the filter.

ClipsSlots

Replacing the Oven Light

WARNING

•To prevent an electrical shock hazard and/or personal injury, make sure that power to the range has been disconnected and that the light fixture is cool before replacing the light bulb.

•Always ensure that the lens cover is in place when using the oven. The lens cover protects the bulb from breakage caused by high oven temperatures or mechanical shock.

•Replacing the lens cover without lining up the cutout with the light socket will damage the light fixture.

•Do not use a screwdriver to remove the lens.

Light bulb replacement is considered a homeowner maintenance operation. If the light does not work, before replacing it, please consult the Problem Solution Guide on page 18.

1.Replace the light bulb only with Dacor part number 107112. See page 20 for ordering information. IMPORTANT: Do not touch the replacement halogen light bulb with your fingers. Halogen bulbs are sensitive to the oils from your hand. The oils from your hand will stick to the bulb and may cause it to burn out faster than normal.

2.Disconnect the range power cord from the elec- trical outlet.

3.Hold your hand under the lens for support and gently pry it loose using a spatula or table knife. Pull the lens cover straight out.

Light

fixture

Bulb

Light

socket

Lens cutout

Lens

4.Grasp the old bulb and pull it straight out of the socket.

5.Using a glove, insert the new bulb into the socket.

6.As you reinstall the lens cover, line up the cutout on the inside rim with the light socket. Gently press it into its original position.

7.Reconnect the power cord.

17