Setting Up Your Range
Cooktop Assembly
The burner rings spread the flame evenly around the burner cap. All burner parts must be properly seated for proper burner lighting and operation.
To assemble the burners:
1.Remove the burner rings, burner caps and grates from their shipping packages.
2.Install the burners as shown below. Gently twist each piece back and forth after installation to make sure it is properly seated. A small gap below the burner ring is normal when installed properly.
3.Gently set the grates on top of the spill tray. Put the legs of each grate inside the corresponding dimples.
Ridge on bottom
STEP 3: Set inner 
SimmerSear burner
cap on center of SimmerSear burner base. Line up ridge on bottom of cap
Inner burner cap
Outer burner cap
Ridge on bottom of burner cap
with pins on center of burner base.
STEP 2: Set outer SimmerSear burner cap on SimmerSear burner ring. Make sure it is centered on top.
STEP 1: Install SimmerSear burner ring on SimmerSear burner base. Line up indentations on bottom of burner ring with pins on top of burner base.
Burner ring
Pin on burner base
STEP 2: Install all standard burner caps. Ridge on bottom of caps must surround top of ring.
STEP 1: Install 
standard burner rings on standard burner bases. Put holes on edge of each ring over
the igniter. Center tabs on bottom of each ring in hole in center of each base.
Igniter hole
Burner ring -
top view
Igniter on burner base
SimmerSear Burner Assembly
(left front burner only)
Standard Burner Assembly
(left rear, right front, right rear burners)
6