Dacor DR30GFS, DR30GIFS, DR30GIS manual

DR30GS, DR30GFS, DR30GIS, DR30GIFS

Document # PG05-007						Revised 04/04/13 Page 1/5
		Distinctive™ 30” Wide				PLANNING
		All Gas Ranges				GUIDE
	All tolerances ±1/16” (±1.6 mm) unless otherwise noted.
					warning
			•	Observe all governing codes and ordinances during planning
				and installation. Contact your local building department for
				further information.
			•	This appliance must be installed in accordance with the
				accompanying installation instructions.

46 3/4” (118.7 cm) Front of open door

28 9/16” (72.5 cm) Front of handle

28” (71.1 cm) Front of knobs

26 1/8” (66.4 cm) Front panel

24” (61.0 cm) Rear of front panel

1 1/8” (2.9 cm) Backguard thickness

NOTE: Models DR30GS and DR30GFS are not compatible with a raised vent.

External handle shown, some models have integral handle

(see inside cover)

Product width:

29 7/8” (75.9 cm)

9” (22.9 cm) Grates extend Backguard1* 1” above trim

DR30GI[F]S: 1/4” (6.4 mm) thick top trim

DR30G[F]S:

Full stainless

steel side panels

DR30GI[F]S: 3 1/2” (8.9 cm)2 partial stainless steel side panels

(removable)

6” (15.2 cm) 3” (7.6 cm) backguard* backguard*

1 3/4” (4.4 cm) backguard*

1

* See table for compatibility

35”

(88.9 cm)

to

37”

(94.0 cm)

Overall Depth Dimensions - side view

Part Number	Description	Compatibility
AER30GLBG	Low profile (1 3/4 inch)	Standard on models DR30GIS, DR30GIFS
		Optional on models DR30GS, DR30GFS
AERB30G03	3 Inch	Optional on models DR30GS, DR30GFS
		NOT compatible with models DR30GIS, DR30GIFS
AERB30G06	6 Inch	Standard on models DR30GS, DR30GFS
		NOT compatible with models DR30GIS, DR30GIFS
AERB30G09	9 Inch	Optional on models DR30GS, DR30GFS
		NOT compatible with models DR30GIS, DR30GIFS
1 Only	backguard model AER30GLBG is compatible with a raised vent.

Available Backguards

All specifications subject to change without notice. www.dacor.com Phone: (800) 793-0093