Installation Instructions

Reinstalling the Oven Door

warning

To avoid personal injury or damage to the door from it falling off its hinges:

•Make sure that the notch on the bottom of each hinge rests on top of the lower lip of each hinge receptacle before attempting to open the oven door.

•Rotate the hinge locks toward the front of the range immediately after installation of the door.

•On double ovens, install the top door first to reduce the chance of damaging the lower door during instal- lation.

1.Grasp the oven door on opposite sides and hold it at a 15° angle from the front of the oven. Slide the hinges into the hinge openings, resting the bottom of the hinge arms on the hinge receptacles. Continue to hold the door at a 15° angle with one hand while pushing in on each of the bottom corners of the door. Push until the notch on the bottom of each hinge slips over the lower lip of each hinge receptacle.

2.Lower the door to the fully opened position.

3.Rotate the two hinge locks toward the oven.

4.Slowly and carefully open and close the door complete- ly to ensure that it is properly installed.

Verifying Proper Operation

1.For stainless steel ovens, peel off the protective layer of plastic that covers the stainless steel surfaces.

2.Remove any packaging from inside the oven(s).

3.Slide the oven racks onto the supports inside the oven chamber(s) according to the use and care manual.

4.Turn on power to the oven at the circuit breaker or fuse box.

5.Follow the prompts on the oven’s display to set up the user preferences and wireless network settings for the oven.

6.Touch MAIN MENU key on the display (UPPER on double ovens).

7.Touch the BAKE key on the display. The default bake temperature should appear on the display.

8.Press START/CONTINUE. After 3 minutes, open the door to make sure the air inside the oven has begun to heat.

9.Press CANCEL/SECURE (CANCEL UPPER on double ovens).

10.On double ovens, touch LOWER, then follow steps 7 through 9 for the lower oven.

11.If the oven does not operate properly, follow these troubleshooting steps:

◊Verify that power is being supplied to the oven.

◊If power is being properly supplied, turn off power at the circuit breaker or fuse box and check the electrical connections.

◊Turn on power and repeat the above heating test.

◊If the appliance still does not work, contact Dacor Distinctive Service at (800) 793-0093 ex. 2822. Do not attempt to repair the appliance yourself. If you need service, be sure to have the model and serial numbers available when you call. See page 3

for location.

Notch on bottom of hinge

Lower lip of hinge receptacle

13