Installation Instructions

Level and Adjust the Range Height

1.Raise or lower the range until it is the same height as the counter-top. To adjust the height, turn the foot on the bottom of each leg as shown below.

2.Use a level to make sure that the range does not tilt front to back or side to side. Readjust the legs if necessary.

Rear

Back of

Leg

Range

 

2 1/8” *

 

up down

* Distance to floor: 2 7/16” to 4 9/16”

Install the Anti-Tip Bracket and Foot

1.Locate the anti-tip foot and lower it until it is 1/16" (2 mm) off the floor. See the bottom left diagram.

Back of Range

2.Locate the anti-tip bracket included in the parts box.

3.Install the anti-tip bracket on the floor using the four (4) included screws. See the diagram below for location.

Top View

H

J

Changing the Backguard (Models ER30D and ER30D-C)

Models ER30D and ER30D-C come standard with a 3” backguard installed. The 6” and 9” backguards are optional.

To change the backguard:

1.Remove and retain the three (3) chrome screws on the front of the existing backguard.

2.Loosen the upper screws on the back of the side panels.

3.Slide the existing backguard off the unit.

Loosen Screw

2 Places

4.Place the new backguard over the back of the range.

5.Fasten the backguard using the existing screws.

6.Tighten the upper screws on the back of the side panels.

New Backguard

Height Varies

Back of

 

 

Range

Tighten Screw

Range

Right

2 Places

 

 

Side

 

Backguard Installation

ANTI-TIP BRACKET PLACEMENT

H6 5/8” (168 mm)

J 6 3/8” (162 mm)