Installation Instructions

3 Inch Side Panel Kit Installation for Model ER30DSR (continued)

Locate the center mounting hole. Remove and retain the screw attached to the chassis beneath it.

5.Insert the tabs on the trim piece into the slots on the range.

6.Use the hex head screw (83023) removed from the side, a Torx head screw removed from the kick panel and the hex screws from the kit to attach the side panel to the range.

Three (3) hex head screws attach the side. One (1) Torx head screw (83709) inserts through the end cap hole to attach the top of the side panel. One (1) Torx head screw (83709) inserts through a hole in the front panel to attach the bottom of the side panel.

9.With the door closed, reattach the kick panel to the range by snapping the ball studs on the back of the panel into the holes on the front panel of the range.

Hex screw

Side Panel

Torxscrew

Hex screw

Hex screw

Torx screw

Front panel

3 Inch Side Panel Installation

7.Reinstall the end cap.

10.Open the door and reattach the kick panel top screws removed in step 1.

Space between

 

door and oven

Reattach kick panel

opening

 

with existing screws

8.Repeat steps 3 to 7 for the right side panel. NOTE: There is an additional hex screw (83023) in the kit for the right side panel because the center mounting screw is not reused as with the left side (do not perform step 4).

11