Installation Instructions

Installing the ERV Trim Kit (Model ER30DSR)

To install a raised vent with self-rimming model ER30DSR, you must install the optional ERV trim kit.

To change the trim on model ER30DSR:

1.Remove and retain the seven (7) chrome screws that hold the existing trim pieces in place.

2.Slide the existing trim pieces off the range.

Trim Removal and Installation

3.Slide the new trim pieces onto the range.

4.Fasten the new trim pieces in place using the existing screws.

Installing the 3 Inch Side Panel Kit (Model ER30DSR)

For self-rimming installations with non-standard countertop depths, installation of the optional side panel kit may be necessary to cover the sides of the range that protrude from the cabinet.

To install the side panel kit:

1.Open the oven door. Remove and retain the two (2) screws on the top of the kick panel. The screws are accessed through the space between the door and the oven opening.

Space between

 

door and oven

Remove and

opening

 

retain screws

2.Close the door. Remove and retain the two screws from the back of the kick panel as shown below. Pull the kick panel free from the front of the unit.

Kick Panel

Remove and

retain screw,

 

both sides

3.Remove the left end cap retaining screw from under the rim of the control panel and remove the end cap.

End Cap

4.Hold the left side panel in position on the side of the range.

Side Panel

Center mounting hole

Left side only: Remove and

reuse this screw.

Remove Center Screw on Left Side

10