Dacor ETT304, ETT365, CERB365, CER304 manual Setting the Controls

Setting the Controls

NOTE:

When at its highest setting, the heating element may cycle off due to the protection of the temperature limiter built into each element. This temperature limiting occurs automatically to prevent exceeding the maximum allowable surface temperature and to maintain the constant desired heat level. The element will cycle back on after it has cooled to a safe temperature.

ETT Models

To turn an element on, tap the “ON/OFF” key then tap the up arrow for the desired element. The element will come on at a setting of “5” and may be adjusted up or down by pressing the appropriate key.

To activate the Dual Element, tap the “ON/OFF” key then tap the Dual Element Indicator to activate the outer ring of the element. It will come on at a setting of “5”, then tap the up indicator for desired temperature setting.

To turn an element off, tap the “ON/OFF” key. You may turn off all active elements at the same time by tapping twice on the Dacor logo located below the controls.

ETT Secure Lockout

To avoid accidentally turning the cooktop on while cleaning it, activate the “Secure Lockout” feature.

To lock out the cooktop:

Press and hold the DACOR logo for 3-4 seconds and the cooktop will be secured from use. You will hear three beeps and a light will illuminate directly above the DACOR logo indicating that the cooktop is secure. The control panel is now disabled and may be cleaned without activating any functions.

To unlock the cooktop:

Press and hold the DACOR logo for 3-4 seconds. You will hear three beeps and the light will go out. The control panel is now ready for use.

NOTES:

1.For maximum safety, the cooktop will be in the “lock out” mode when first installed, or whenever power is interrupted. Follow the “Unlock” instructions above to reactivate the control panel.

2.To turn off multiple burners all at one time - tap the Dacor logo twice.

6 1/2"	7 3/4"	6 1/2"	9"	7"
1200W	1800W	1200w	2100w	1500w

51/2"

1000W

9 3/4"	7"
2400W	1500W

Model ETT304

Top View

5 1/2"

1000w

9 3/4"	7 3/4"
2400w	1800w

Model ETT365

Top View

CER 304 Model

Push down and turn the knob to the desired temperature setting. The control knobs can be turned either clockwise or counterclockwise to the desired temperature setting. The knob that controls the Dual Element may be pushed down and turned counter-clockwise to heat the single inner element or clockwise to heat both the inner and outer elements. All knobs may be positioned below setting #1 to achieve the lowest temperatures possible.

7"	5 1/2"
1800W	1000W

9"
2200W	5 1/2"
	1000W

9" 6" 7"

2400W 1500W 1800W

800W

7 1/2"	5 1/2"
2000W	1000W
Model CER304		5 1/2"	7"
	Top View	1200W	1800W

NOTE: (CER models only)

The Element ON Indicators are located below each knob.

Figure 7: Model CERB365

Top View

3