Planning the Installation

Electrical Specifications

important

•Preheat times and cavity temperature recovery times will be increased slightly if operating on less than a 240 Vac circuit.

•This appliance is provided with electrical connection leads in a flexible metal conduit. These leads may be a smaller gage than the standard household wiring of the dedicated supply circuit, but they are suitable for connection to these circuits under the jurisdiction of the National Electric Code, and/or the local inspection authority.

•Locate the junction box so that the wiring may be dis- connected without removing the oven from the wall.

It is the owner’s responsibility to ensure that a qualified electrician performs the electrical connection of this appli- ance. The electrical installation, including minimum supply wire size, must comply with the National Electric Code ANSI/NFPA 70 (latest revision) and local codes and ordi- nances.

A copy of this standard may be obtained from:

National Fire Protection Association 1 Batterymarch Park

Quincy, Massachusetts 02269-9101

The correct voltage, frequency and amperage must be supplied to the appliance from a dedicated, grounded, single phase circuit that is protected by a properly sized circuit breaker or time-delay fuse. If a time-delay fuse is utilized, fuse both sides of the line (L1 and L2).

Model Type

Dedicated Circuit

Total

Requirements

Connected Load

 

Single 27”

240 Vac 60 Hz.,

 

 

4 wire*, 30 Amp.

4.6 kW (19.5 Amp.)

Single 30”

dedicated

 

 

 

 

Double 27”

240 Vac 60 Hz.,

 

 

4 wire*, 50 Amp.

9.25 kW (38.9 Amp.)

Double 30”

dedicated

 

 

 

 

* Two 120 Vac hot (L1 and L2), one neutral, one ground.

The above electrical ratings are for reference only. For the exact ratings see the product data plate. See page 3 for location.

Installation Instructions

Parts List

Verify that all the parts are included. If any item is missing or damaged, please contact your dealer immediately. Also make certain that you have all tools and parts necessary to ensure a proper installation before proceeding.

•Exhaust deflector

◊27” defector - PN 46050B or

◊30” deflector - PN 46051B

•Mounting and exhaust deflector screw kit

◊Single oven screw kit - four (4) 3/4” mounting screws, four (4) 1 1/4” mounting screws and three

(3)exhaust deflector screws - PN 700486-1

or

◊Double oven screw kit - Six (6) 3/4” mounting screws, six (6) 1 1/4” mounting screws and three

(3)exhaust deflector screws - PN 700486-2

•Meat probe, one (1) - PN 72723

•Broiler grill and pan - PN 12157

•Standard oven racks two (2) for a single oven, five (5) for a double oven

◊27” standard rack - PN 72747 or

◊30” standard rack - PN 72713

•GlideRack™ oven rack, one (1)

◊27” GlideRack™ oven rack - PN 72948 or

◊30” GlideRack™ oven rack - PN 72949

•Stainless steel cleaner - stainless steel models only PN A302

•Product literature

9