Top Right Handle Installation
STEP 5: Mount the handle to the right door by slid- ing the holes on the back over the handle mounting studs on the right door. Make sure the set screw holes face toward the center of the refrigerator. Loosen the set screws if necessary to allow the handle to slide into place.
STEP 6: Carefully tighten the set screws into place using the 3/32” Allen wrench. Be careful not to scratch the finish.
STEP 7: Check to make sure the handle is firmly attached.
Set Screw | Handle Mounting |
Holes | Studs |
Top Left Handle Installation
STEP 8: Mount the remaining handle to the left door with set screw holes toward the center of the refrigerator. Loosen the set screws if neces- sary to allow the handle to slide into place.
STEP 9: Open the left door while holding the handle in place to prevent damage to the other handle during step 10.
Handle Mounting
Stud
Set Screw
Hole
STEP 10: Carefully tighten the set screws into place using the 3/32” Allen wrench. Be careful not to scratch the finish.
STEP 11: Check to make sure the handle is firmly attached.
Set Screw
Hole
Handle Mounting
Stud
Dacor ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: (800)
