AMX NXT-CV7, NXD-CV7 instruction manual Unpacking the Panel, Installing the Internal Components

Installation

Installation

NXT panels are mounted onto flat (horizontal) surfaces in either a stand-alone or combo (NXT atop an NXA-BASE/1 battery base) configuration. NXD panels are installed into either a pre-wall surface (using a CB-TP7 conduit/wallbox) or a solid surface (using either solid surface or drywall screws).

It is recommended that if you are planning on upgrading your panel components (flash and wireless), you do so before beginning any panel installations.

Unpacking the Panel

1.Inspect and confirm the contents of the shipment box to verify you have all specified parts. Refer to the Specifications for 7" Widescreen Video Touch Panels section on page 3 for more information about included and optional accessories.

2.Carefully remove the panel from the shipping box.

3.Carefully peel the protective plastic cover from the LCD.

If the protective plastic LCD cover is not removed, the panel may not respond properly to touch points on the LCD or allow proper screen calibration.

Installing the Internal Components

Installation of the internal components such as the upgraded Compact Flash and the NXA-WC80211B/CF Wireless card are described in detail within the following sections:

NXA-WC80211B/CF 802.11b Wireless Card (FG2255-03)section on page 14.

NXA-CFSP Compact Flash (2116-3x)section on page 21.

Installing the No-Button Trim Ring

The NXD-CV7 panel is shipped from AMX with the default Button Trim Ring already installed. The unit is also shipped with an separate Trim Ring containing no button openings (a No-Button Trim Ring) that allows you, if desired, to change the default configuration of the NXD panel Faceplate to that with no-button openings. In order to install this included No-Button Trim Ring, you must first remove the factory-installed default Button Trim Ring, the six small buttons, and associated two clear light pipes.

1.The outer Button Trim Ring is secured to the Faceplate with plastic latches. To remove the Faceplate, simply pull it away from the panel by gently tugging it outwards until the entire Faceplate comes away from the panel.

2.Turn the Faceplate over to expose the inside surface and view the Trim Ring latches (FIG. 30).

3.In a single motion, press down and then outwards on the three Trim Ring latches located along the top of the internal surface of the Faceplate to begin removing the Button Trim Ring.

7" Modero Widescreen Touch Panels 29