CV7 Touch Panel Accessories

7.Align the rear pegs and gently push the rear of the panel downwards until it is mounted atop the battery base.

The battery base CANNOT be hot-swapped. An NXT can not be receiving power (through a connected power supply) and then be connected to a battery base. Always POWER OFF the panel before installing the NXA-BASE/1.

8.Slide the rear battery locking slider in the opposite direction. This turns the latching mechanism and secures the panel to the base.

9.Upon successful connection, the AMX logo appears on the panel to indicate that the panel is properly connected and receiving power.

Charging the NXT-BP using the NXA-BASE/1

1.Insert the single battery into the battery compartment shown in FIG. 26 on page 24.

2.Follow the procedures from the previous sub-section to attach the NXT-CV7 to the NXA-BASE/1.

3.Insert a 2-pin connector from a power supply to the rear PWR connector on the NXT-CV7 Modero panel. Refer to the Battery Base Page section on page 95 to view the charging progress of the connected NXT-BP.

NXT-CHG Battery Charger Kit (FG2255-50K)

The NXT-CHG Kit includes one charger and two NXT-BP batteries. The optional NXT-CHG Modero Power Station (FIG. 28) is a two-slot, stand-alone battery charger that can be used to recharge up to two NXT-BP batteries. The batteries are charged in the order they are inserted into the charger. The NXT-CHG Slot 1 has the feature of being able to completely discharge and recharge (recalibrate) a battery.

Battery Life indicator

NXT-BP Modero Power Pack (battery)

NXT-CHG Modero Power Station (charger)

FIG. 28 NXT-CHG Kit (consists of one NXT-CHG charger and two NXT-BP batteries)

7" Modero Widescreen Touch Panels

25

 

 

 

 

Page 33
Image 33
AMX NXT-CV7, NXD-CV7 instruction manual NXT-CHG Battery Charger Kit FG2255-50K, Charging the NXT-BP using the NXA-BASE/1