AMX NXT-CV7, NXD-CV7 Master Connection, ICSNet is not a supported option on this panel

Firmware Pages and Descriptions

System Connection Page Elements (Cont.)

Master Connection:

Type

Mode

System Number

Master IP/URL

Master Port Number

Username/Password

Sets the NetLinx Master communication values:

Sets the NetLinx Master to communicate with the panel via either USB or Ethernet. This is based on the cable connection from the rear.

ICSNet is not a supported option on this panel.

•Ethernet is a CAT-5 cable (10/100Base T terminated in an RJ-45 connector) used to network computers together and is used in most LAN (local area networks). This description is also used to refer to both wired and wireless communication.

•USB option cannot be used on Modero panels which are not equipped with a rear USB port.

Cycles between the different connection modes (URL, Listen, and Auto)

(ETHERNET Only - disabled when USB is selected)

•URL - In this mode, enter the IP/URL, Master Port Number, and username/password (if used) on the Master.

-The System Number field is read-only because the panel obtains this information from the communicating Master.

•Listen - In this mode, add the Modero panel address into the URL List in NetLinx Studio and set the connection mode to Listen. This mode allows the Modero touch panel to "listen" for the Master’s communication signals.

-The System Number and Master IP/URL fields are red-only.

•Auto - In this mode, enter the System Number and a username/password

(if applicable). This mode is used when both the panel and the NetLinx Master are on the same Subnet and the Master has its UDP feature enabled. - Master IP/URL field is read-only.

Allows you to enter a system number. Default value is 0 (zero).

(ETHERNET Only - disabled when USB is selected)

Sets the Master IP or URL of the NetLinx Master.

(ETHERNET Only - disabled when USB is selected)

Allows you to enter the port number used with the NetLinx Master.

•Default value is 1319. (ETHERNET Only - disabled when USB is selected)

If the target Master has been previously secured, enter the alpha-numeric string (into each field) assigned to a pre-configured user profile on the Master.

This profile should have the pre-defined level of access/configuration rights.

7" Modero Widescreen Touch Panels 111